W-L-A seam

Is this rendition of the W-L block the intended design of the seam? I am asking because the source files are not as precise to infer the information from them. Was the intention to have 45mm dovetails with -22.5 to 22.5 around 900mm datum line? Or was the intention different?

Could you clarify the question?

Sure - the question is specifically about the design intention, or if you will, about the drawing constraints. Questions like:

  • what was the intended radius of rounded edges
  • what were the actual lengths that govern the mouth of the pieces
  • is the angle a constraint or is it a derivation of some other constraint
  • what exactly was the intended length of the seam central horizontal position

Basically I am looking at the design properties and rationale, not the measures. Published models are sometimes self-explanatory (e.g. a 150.00123 wide tab is meant to be 150mm wide). But some of the connections do not reveal their intended design, and reverse engineering those is not my favourite game :sweat_smile:

In a time before time you would call this a technical drawing :blush: