3.6m, 1.2m and 1.5m blocks

Using WikiHouse Designing with Skylark
1

Hello

I am looking to see if anyone has made Skylark 200 wall blocks for the heights of
3.6m
1.2m
1.5m
that they would be willing to share?
I am designing a tinyhouse with a loft bed and struggling to work out the pattern for the bowties as there will be 2.1m wall blocks that intersect with a floor block but in the living space there is no intermediate floor block so these will go to roof level

2

Hi Aiden-Junor, I quickly made up some blocks that might work. I haven’t tested them in a house design, as I’ve been using SKYLARK250, but it should be apparent whether they work or not.

I work in Fusion360, and so either added a mid section(as per the 3600mm), or removed a section. Let me know if you need corner blocks as well.

Hope that helps. Use them as a guide only, I don’t have the actual formula for building the blocks, so they are not guaranteed to be correct. If it turns out that they don’t work, I’ll remove the post so as not to cause confusion :slight_smile:

Also, the 3600mm block does not have a join in it’s length, as I wasn’t sure where it should go.

Cheers, André
Aiden_Junor - Custom Sizes.zip (3.9 MB)